Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterOlympia Chimney Chimney Repair in Quakertown: What to Know First
We repair Olympia Chimney products in Quakertown, and we do it as an independent Olympia Chimney service provider, not a factory-authorized shop. That matters because we’re free to tell you when a repair is worth doing and when a part from another brand, like a DuraFlex liner component or HeatShield resurfacing material, will actually serve you better and cost less. Most Olympia Chimney repairs take us a day, sometimes two if we’re tearing out and rebuilding above the roofline. The honest price posture is this: we quote before we touch anything, and the number you hear on the phone is the number on the invoice.
This page is for homeowners in Quakertown and the surrounding parts of Bucks County who have an Olympia Chimney system, know it’s acting up, and want straight answers. Call (484) 603-6713 and you’ll get a live person, probably Wendell himself.
How Olympia Chimney Products Fail - and How We Fix Them
- Olympia galvanized chimney caps rusting out at the base. We see this constantly in Quakertown because the freeze-thaw cycles up here are brutal on thin-gauge metal. The cap looks fine from the ground, but the mounting collar has rotted through where it meets the flue tile. We replace it with a heavier-gauge cap, frequently a Famco or Copperfield unit, and re-bed the whole thing so it doesn’t wobble in a January wind.
- Mortar joints on Olympia chimney crowns cracking and letting water behind the brick. The original crown was often poured a little thin. Once Quakertown gets a few winters of snow sitting on that crown, then melting, then freezing again, the cracks open up. We grind out the loose material, lay down a proper crown with an overhang drip edge so water sheets off instead of running down the brick face, and seal it.
- Flashing leaks where the roof meets the Olympia chimney stack. Most of the time it’s not the chimney, it’s the step flashing or counterflashing that was installed in a hurry. In the older neighborhoods around Main Street and Tohickon Creek, we’ll find flashing that’s 40 years old and pulling away from the masonry. We cut in new flashing, seal the seams, and test it with water before we leave.
- Spalling brick face on the exterior chimney. This one is Quakertown weather through and through. Water gets into the brick, freezes, expands, and pops the face off. We remove the damaged brick, match it as close as the brickyard allows, repoint the joints, and then waterproof the chimney so the next freeze doesn’t do the same thing to the next brick.
- Clay tile liners inside older Olympia Chimney systems cracked from a chimney fire. If someone burned those manufactured logs or a load of pine before you owned the house, the liner may already be compromised. We run a camera up there, show you the footage on the spot, and tell you if you need a HeatShield resurfacing or a full stainless liner. You’ll see the crack with your own eyes before we recommend a dollar of work.
Our Olympia Chimney Chimney Repair Process
- 1
You call, a person answers. Usually Wendell. He asks what you’re seeing, sets a time that works, and tells you upfront whether there’s a trip charge. If you’re in our service county, there isn’t one.
- 2
We show up on time and walk the property with you. We go up on the roof, take photos, and run a camera down the flue so we’re both looking at the same thing. No mystery verdicts.
- 3
We explain what we found in plain English and price the repair before any tool comes off the truck. If it doesn’t need doing, we’ll tell you that too. Part of the job is knowing when to say no.
- 4
For Olympia Chimney parts, we decide OEM versus proven aftermarket case by case. Some pieces are worth matching exactly. Others, like caps, flashings, and some crown materials, are honestly better from Famco or Copperfield. We’ll tell you why we picked what we picked and what it costs either way.
- 5
We make the repair, test it, and clean up the job site like we were never there. Every job gets a final inspection, a photo report, and the 90-Day Done Right Promise in writing.
- 6
One call brings us back. If anything isn’t right within 90 days, Wendell comes back and makes it right. No charge, no argument.
What Olympia Chimney Chimney Repair Costs in Quakertown
Here are the numbers we actually quote around Quakertown for Olympia Chimney systems. These are honest ranges, not teaser prices designed to change at your door.
- Chimney cap replacement: $140 to $280 depending on flue size and whether the base needs rebuilding.
- Flashing repair or replacement: $350 to $750 depending on roof pitch and how much old material is in the way.
- Crown repair with resurfacing: $600 to $1,100. Full crown removal and repour runs higher.
- Tuckpointing and mortar repointing: $30 to $50 per square foot of wall surface, depending on joint depth and access.
- Spalling brick repair (a few bricks): $200 to $400 for typical face replacement plus sealant.
- Full chimney waterproofing: $250 to $500 depending on surface area and prep work.
What moves the price: roof pitch, chimney height, flue access, and whether we find rot behind the brick that wasn’t visible from the ground. We’ll show you the camera footage and quote you line by line before starting. Call (484) 603-6713 for a free estimate. And remember, we take $40 off any repair over $200.
Why Quakertown Homeowners Call Top Hat Chimney for Olympia Chimney Work
Wendell Pike put his name on this company in 1999, and he’s been climbing Quakertown roofs ever since. You’ll get him or a member of his small crew, not a rotation of strangers from a national chain. Every job carries the 90-Day Done Right Promise in writing, and Wendell answers the phone himself more often than not. The crew works with DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield, so when a repair needs a part from a different brand, we’re not reaching across three suppliers and hoping. We already know what fits and what lasts. Ask anyone on your street. They’ll tell you the same thing.
FAQs
We do, but as an independent Olympia Chimney service provider we can’t file warranty claims for you. We’ll give you a detailed written diagnosis with photos and part numbers so you can file the claim yourself, and we’ll handle the repair whether the claim pays out or not. Call (484) 603-6713 and we’ll walk you through what the warranty actually covers.
Depends what’s failing. Caps and flashings are nearly always worth replacing. Crowns can be repaired if the damage is surface-level. But if the liner is cracked or the brick structure is shifting, replacement may be the honest call. We run camera footage on every job and show you what we see, so you’re not buying blind. Call (484) 603-6713 and Wendell will tell you straight which way to go.
Inside our service county, we can usually schedule most repairs within five to seven business days, sooner if it’s a safety issue. A live person answers around the clock, so if you call at 9 p.m. with water dripping into your firebox, you’ll talk to a human. Call (484) 603-6713.
When the job calls for it, yes. When an aftermarket cap, flashing, or crown material is honestly better for Quakertown winters, we’ll use that instead and tell you why. Our goal is for the repair to last, not to pad an invoice with brand markup. Estimates are free, so call (484) 603-6713 and let’s look at it.
Water keeps getting in, and water in a Quakertown winter turns into cracks, spalled brick, and rusted metal fast. Small repairs get expensive repairs. The camera footage and a plain-English verdict, every time, no exceptions. If it doesn’t need doing, we’ll tell you that too. Call (484) 603-6713 and find out what you’re actually dealing with.
Written by Wendell Pike, Owner, Top Hat Chimney at Top Hat Chimney, serving Quakertown and nearby areas.